Oct 20, 2021 · Ive changed everything the CDI , Ignition coil, Spark plug, Starter, Solenoid, fuse, carb is new, Battery is good, im getting compression, just no spark also my wiring is all jacked up, i dont have the handle bar controls, i replaced the key and have a …

Mar 22, 2011 · Most 4-wheeler problems are caused by a loose nut connecting the handlebars and the seat!! You only need two tools in life -- WD-40 and duct tape. If it doesn't move and should, use the WD-40. If it shouldn't move and does, use the duct tape.

Jun 23, 2010 · I just bought a new billet alluminum bearing carrier off ebay! I will be installing it soon and was wondering is there a specific grease to fill it and how do you know that it is full? There were no directions! Any help will be greatly appreciated!

Oct 27, 2012 · This might get kinda long if so, apologies. This fall I bought 2 300ex's, 03 and a 06, both are clean low hours machines. I had reasons for buying the 300 and not a bigger engine/quicker quad, most impotant was these are family machines and some members of the family have limited trail time. So...

Apr 24, 2013 · I have a 2005 Honda TRX300ex all stock. The rear brake reservoir is melting or warping from the heat of the exhaust which is only a few inches away. I do ride some longer 4 to 5 hour long trails, but I have had a trx250 and now a trx300 both have this same issue. The top seems to melt and warp...

Jan 10, 2015 · Hello! Want to thank the community before hand, if it wasn't for this forum, this ATV wouldn't be able to run. 87' trx250x frame, swapped the engine for 93' trx300ex. 87’ 250x Frame 93’ Trx300ex motor 93’ Wiring Harness 01-06' Aftermarket CDI (NO rev limit increase) - Researched and same...

Dec 11, 2022 · I recently got this honda 300ex from a friend and i haven’t gotten anything to work. I got a mew solenoid , new battery. cleaned all grounds. new coil packs and spark plug and haven’t made progress. Still no spark and what bothers me is also no neutral light.No power to none of the front or rear...

Mar 23, 2014 · Hello everyone, i was wondering if anyone could help me with the pinout of the cdi. I have a manual and it explains the colours of the wires but does not show what wire goes to what pin. I have the 6 pin cdi with the fan wire. I am putting this motor into …

Mar 28, 2011 · My 1988 TRX300 starts fine but will not keep running when I let go of the start button, it dies, if i keep the button pushed in, it will keep running. Also, if it won't start on the first try, I have to shut the key off and on before it will get spark again. Are these two seperate problems? Do I...

Apr 28, 2012 · ok got our son a 06 honda TRX300ex and I need to set the clutch so when you pull it in and then let it out. its want it to grab better.right now its over...