Oct 20, 2008 · Hello guys, I am trying to configure a shdsl module but I don't get to up the Atms interfaces created. I think is a wire problem because I see the following message when the show controller shdsl command. Controller SHDSL 0/3/0 is UP Group (0) info: Type: 4-wire g.shdsl, status: Configure Firmware...

Oct 20, 2008 · Hello guys, I am trying to configure a shdsl module but I don't get to up the Atms interfaces created. I think is a wire problem because I see the following message when the show controller shdsl command. Controller SHDSL 0/3/0 is UP Group (0) info: Type: 4-wire g.shdsl, status: Configure Firmware...

Oct 15, 2015 · Hello, Assuming your routers can host up to two G.SHDSL cards, then yes, this network could be implemented as shown in your Packet Tracer topology. Please note that with 4-wire connection, the ordinary G.SHDSL back-to-back connection would operate at approximately 4.608 Mbps at most. Is there any specific reason why you would want to build your network like this, with back-to-back G.SHDSL ...

Oct 27, 2013 · I have a router 2620XM with a WIC-1 SHDSL-V3 card installed that allows me to set up the configuration parameters properly (I'm using this doc as a reference). On the other hand, I have a cisco 1841 with another WIC-1 SHDSL-V3 card that is causing me trouble.

The Express 6540 Series is housed in a standalone plastic case available in AC, DC, or SHDSL span/DC powered models. The front panel provides pushbuttons for opera-tion of local and remote port loopbacks and built-in BERT testing, and has LED status indicators for data port, loopback, and BERT conditions.

Oct 9, 2015 · hello how are you i want to connect two routers using SHDSL using copper line the first router is Cisco 1921 ----- CO the second router is Cisco 888 ----- CPE can any one help me about configuration and how to connect two routers together 1921 using RJ-45 in SHDSL slot, 888 using RJ-11 in SHDSL sl...

Nov 6, 2008 · Hi, I have a Cisco 1841 router with the following modules installed: HWIC-1ADSL HWIC-2SHDSL For some reason the HWIC-2SHDSL module in slot 1 is not supported / disabled in this slot according to the 'show diag' command. (Please see attached show_diag.txt) From the configuration manual the minimum ...

Apr 12, 2017 · Cisco Community Technology and Support Networking Routing SHDSL-EA: FPGA DNLD STATUS failed

Jan 21, 2009 · I need 4 SDSL ports on the 2800 router. Is i have to buy 4 WIC-1SHDSL-V3 cards for that? Secondly Can you please provide me the template configuration to configure the router for SDSL link? What information i need to get from the ISP to setup this link? your help will be highly appriciated. Thank...

Oct 26, 2010 · Hi all I have 2 shdsl modems connected to cisco 2821 router via serial interface, and another shdsl routers that is configured as bridge (not connected to cisco). so I have 3 branches that is connected via shdsl. I want to replace these modems/router with Cisco Hwic- 4shdsl What is confusing me i...