Feb 11, 2005 · So, I got a couple sets of ROX Risers, a 1.5" up and back fixed set, and a 2" Anti-Vibe Adjustable set, and thought I would show the install process. Later I will review their effectiveness. (Note, most risers will install the same way.) Very nicely machined, and comes with new caps as well.

Feb 13, 2020 · Rox Risers Installation 2019 Indian Chieftain Limited with OEM Mid-Rise Handlebars I've seen some very helpful posts from folks who've installed Rox Risers on their 2018 and earlier Chieftains, but none for the 2019. Since Indian introduced a redesigned faring for 2019, I'm offering up this "tutorial" for the 2019 install.

Jun 14, 2011 · I had the Tusk ones on my '06 KLR650, they suck. They raise the bars but also push them back too much. I switched to Rox basic $75 risers and love them, they are infinitely adjustable, so I could raise the bars up and roll them forward to where I wanted them. I think you just need better grips, for anti vibration.

Oct 6, 2006 · 6) Rotate risers where you want them 7) Torque front (bigger) bolts of OEM mount 8) Torque Rox clamp bolts Btw: a lot of people found that the hole in the Rox riser is perfectly aligned to torque the rear bolt for a very good position for most riders. That worked perfectly well for me when I was using the Rox risers.

Jun 17, 2024 · Regarding the Rox risers. Here's what I learned talking to Rox a millions times. I used painter's tape to cover my handlebars, gauge, front fender. I didn't want to get anything scratched. For some reason, my gauge still did. I laid towels down on the gas tank in …

Jan 31, 2017 · Rotate the Risers full forward and then tighten the rear bolts to 20N.m. It will be hard to hand rotate the risers back but it's doable. Rotate the Risers back until you have enough room to insert the star bit to tighten. Undo the Rox bolts and install the handlebar, positioning in the center (use the pencil line) and "level". Tighten the Rox ...

Jun 13, 2019 · The risers mount into your OEM bar clamps and you will use caps to secure the risers that Rox will provide. You will then take your OEM bar clamp/ Speedo assembly and secure your bars on top of the risers with that. The risers will get you much more comfy on the bike. the best part is that all your OEM cables and lines work with the risers.

Oct 9, 2009 · Thank you Rox Risers for listening to your customers who wanted risers without changing the brake line. Here's the info as listed on their site: New Low Pro 1 3/4"rise x 1 1/8" Stem Clamp x 1 1/8" Handlebar Dual Sport Motorcycle Pivoting Risers New Super Low Pro 1-3/4" center to center rise for BMW F800GS and KTM's.

Aug 23, 2008 · Another option for the 850GS is to use the Rox 1-1/2" Barbacks and keep the GPS on top of the clamps. I ordered a set of these barbacks and have the option of mounting my Nav V as in the photo below, but I'm 99% sure that I'll mount my Nav above the TFT.

Dec 16, 2018 · I installed the Rox risers on my 2017 Chieftain Limited. i watched every video on this forum and read install steps. I combined all the tips, no short cuts. I did move the seat back and take off the console and removed the bars completely. I did …