Mar 1, 2019 · Now if you want to enter into configure terminal and you don’t want to type entire syntax like configure terminal you can just type "conf t" so IOS will recognizes that you want to execute the full "configure terminal" command. R1#conf t Enter configuration commands, one per line. End with CNTL/Z. R1(config)#

Apr 14, 2021 · Router#conf t. This command is not supported. Router# Solved! Go to Solution. 6 people had this problem.

Jul 25, 2004 · config t config interface config interface range or config interface-range gi1/0, gi1/22, gi2/2 or config interface-range gi1/1 - gi1/22 play with the “?” and the tab assist to have the cisco ios finish the correct syntax for the command. I wish I could help more but an not currently in from of a terminal. Hope this helps you. Good Luck.

Mar 21, 2020 · Switch # conf t ^ % Invalid input detected at '^' marker. Switch # However, when I try to execute "conf t" in CLI HTTPS, it seems to work: #conf t Enter configuration commands, one per line. End with CNTL / Z. Could someone explain to me the procedure to follow in order to configure my switch ? Thank you in advance and good day !

Jul 3, 2021 · Solved: Hi all just been given a CAP 3502i access point, try to logon and configure the password, but not accept the config t. Is it because this equipted with Light weigh mode IOS? I followed the link bellow:

Jul 23, 2013 · Hello Experts, I have a question about Cisco Aironet 1310 AP, the problem I am getting is that I am unable to enter the conf t mode to configure the AP. I am not sure what could be the problem. I have IOS 12.3 running on it. Please help

Nov 30, 2015 · Hello, I know how to configure a password when a user try to connect on the router locally, the "enable password". R1(config)#enable password mypassword But I can't figure out how to do the same when a user want to configure the router.. Can you help me ? Thanks :)

Nov 14, 2008 · I can't issue some commands on a 2801 Cisco Router, like: Router#configure terminal..... or. Router#show running config. It seems the router doesn't recognize these commands. What could be the reason? Thanks. Tauer

Aug 10, 2021 · config ap mgmtuser add username <myUser> password <myPassword> enablesecret <myEnablePassword> <myApName> and now, when I connect to my AP, I can run config terminal Thanks to all for your help

Apr 24, 2018 · When I try to do a config revert of a Cisco 4451 code 16.03.5 an message comes up. I was wondering if anyone know what it is? config t revert timer 10 %No Rollback Confirmed Change pending I enabled archive path flash: should I do archive path