Beryllium metal Metal: A hard, brittle, gray-white solid. CDC - NIOSH Pocket Guide to Chemical Hazards - Beryllium & beryllium compounds (as Be) Skip directly to site content Skip directly to page options Skip directly to A-Z link

However, the revised IDLH for beryllium compounds is 4 mg Be/m3 based on being 2,000 times the OSHA PEL of 0.002 mg Be/m3 (2,000 is an assigned protection factor for respirators; only the “most reliable” respirators are recommended for exposures greater …

Occupational exposure to beryllium occurs at places where the chemical is mined, processed, or converted into metal, alloys, and other chemicals. Health risks exist if beryllium-containing materials are dispersed as a dust, fume, mist, or beryllium-containing solution or suspension that can be inhaled or come into contact with unprotected skin.

Beryllium surface compliance levels (DOE: 10 CFR 850) Equipment release: 0.2 μg Be/100 cm. 2. Housekeeping: 3.0 μg Be/100 cm. 2 (But no information on sampling methodology) “ Analysis by AIHA-accredited lab or equivalent ”

use of beryllium oxide spikes in quality control testing have been included as suggested. However, inclusion of a general beryllium salts or beryllium silicate recovery discussion were not included since the focus of the research is the recovery of the most commonly encountered workplace beryllium compounds (beryllium metal and beryllium oxide).

for analyzing alternative ranges of beryllium concentration. To test a range of 0.005 μg to 0.4 μg of beryllium on the sampling media, 0.4 mL of the sample filtrate is added to 1.6 mL of the detection solution in the cuvettes. The lysine-free dye solution may also be used for obtaining

Apr 6, 2007 · beryllium concentration can be prepared by 10-fold dilution of the stock standards mentioned in the note above. As with the samples, these stock standards are prepared for analysis by add-ing 0.4 mL of beryllium stock standard into 1.6 mL of detection solution (5-fold dilution). Please see Table 2.

fluorescence intensity vs. beryllium concentration (ng/mL) in the stock standard. NOTE: To test a range of 0.05 μg to 6 μg of beryllium on the sampling media, beryllium stock standard solutions are made up using beryllium spectrometric standards diluted with theammonium bifluoride dissolution solution.

Occupational exposure to beryllium occurs at places where the chemical is mined, processed, or converted into metal, alloys, and other chemicals. Workers engaged in machining metals containing beryllium, recycling beryllium from scrap alloys, or using beryllium products may also be exposed to higher levels of beryllium.

beryllium concentration can be prepared by 10-fold dilution of the stock standards mentioned in the note above. As with the samples, these stock standards are prepared for analysis by add-ing 0.4 mL of beryllium stock standard into 1.6 mL of detection solution (5 …