Apr 5, 2014 · There is a procedure in the fsm that uses a multimeter and the ecu to set the vvel at neutral position, then clock the sensor until it outputs the correct voltage.

Jul 27, 2020 · I CANNOT for the life of me get the VVEL position sensor voltages to match. Bank 1 is constant and no issue, Bank 2 reads 0.1v less. If i sync the voltages as per FSM with the …

Jan 18, 2020 · VVEL reference starts at FSM EC-597 2010 revision. Show what you should see on each pin. But see EC-606 shows module pinout.

The automobile fault code p1091 can be caused by a faulty VVEL Actuator Motor Relay, open or shorted VVEL Actuator Motor Relay harness, poor electrical connection in the VVEL Actuator …

Nov 22, 2022 · Your P1092 would be problems with the VVEL system that’s on the driver side. It would be a much easier repair than the one I did since bank 2 is positioned higher up on the …

Sep 2, 2015 · Scanned the car and found fault p1091, vvel act mot pwr. When I clear the fault it comes back instantly before I even start the car. I removed the connector for the top vvel …

The fault code P1606 can be caused by the following: a faulty Variable Valve Event and Lift (VVEL) Control Module, an open or shorted VVEL Control Module harness, and a poor …

You could try bypassing the CAN-L and CAN-H from the VVEL directly to the ECM and see if that changes anything as described in the tech report. The factory data is saying clear the code …

Aug 6, 2014 · Full Carbon Fiber Nissan 370z "400zTT" Fully Built 4.0L Twin Turbo 1300hp, 1100whp. Follow me on Instagram at http://www.instagram.com/carbonz. Might have found …

CVTC and VVEL together control the valve phases and its valve events, allowing free-control of the valve timing and lift. This results in more efficient airflow to the cylinder, significantly …