Jun 6, 2010 · My favorite for fuel lines are the hotrod thumb screw clamps from the early 50s. I took this picture just for the hose clamps. I found some NOS EELCO thumb screws a few …

Dec 11, 2012 · There are lots of "rules of thumb" about what should be parallel or pointing up or down. Mostly it's all bunk. Just do the calculations and design a geometry for the handling …

Jan 25, 2025 · Ed drove this up from Kentucky. It was cold, snowing and raining. He was having issues with the carbs icing up, so we built a fine cardboard carb heater.

Jan 16, 2007 · It has two hand held guns, one with a thumb button/trigger. Dial knob reads 0-100, presumably amps. I need instructions and a source for a replacement hand grip. Presume they …

3 days ago · Spreading the gospel of traditional hot rods and customs to hoodlums worldwide.

Aug 1, 2013 · as a rule of thumb, We used 2 degrees per pound of cap on roundy-round dirt track cars. coolant was not allowed , and these run hot ,4- 5000 rpm for 20 minutes at a time So, …

Jan 8, 2016 · Just pull number on plug on the front left bank, pull coil wire to keep it from starting, stick your thumb over the hole, bump it slowly with your remote start button or a buddy on the …

Feb 10, 2008 · I picked up a 1940 Ford truck steering column drop and ignition switch today and I need to know how to take it apart. Everything works on it, but I want to replace the thumb …

Jun 25, 2018 · The 3 hole wheel was a Cal Custom trademark ( not registered). I have never seen an early Superior wheel (pre Grant) with 3 holes. The only superior wheels I have seen that I …

Jan 25, 2025 · from the thumb of Michigan. Boink Rickybop, Feb 11, 2025. SHARE POST #23.