TI’s TL081 is a Single, 30V, 3MHz, 13-V/µs slew rate, In to V+, FET-input op amp. Find parameters, ordering and quality information.

The TL08xH (TL081H, TL082H, and TL084H) family of devices are the next-generation versions of the industry-standard TL08x (TL081, TL082, and TL084) devices.

TL081 is a high-speed operational amplifier integrated circuit consisting of a high voltage JFET and bipolar transistor. It has low input bias currents, trimmed input offset voltage, and high slew rates.

Each of these JFET-input operational amplifiers incorporates well-matched, high-voltage JFET and bipolar transistors in a monolithic integrated circuit. The devices feature high slew rates, low input bias and offset currents, and low offset-voltage temperature coefficient.

Thermal compression or ultrasonic bonding may be used on the doped-aluminum bonding pads. Chips may be mounted with conductive epoxy or a gold-silicon preform. TOLERANCES ARE ±10%. ALL DIMENSIONS ARE IN MILS. PIN (4) IS INTERNALLY CONNECTED TO BACKSIDE OF CHIP. These chips, when properly assembled, display characteristics similar to the TL084.

Description: GENERAL PURPOSE J-FET SINGLE OPERATIONAL AMPLIFIER. Manufacturer: STMicroelectronics.

The TL081 is a low cost high speed JFET input operational amplifier with an internally trimmed input offset voltage (BI-FET IITMtechnology). The device requires a low supply current and yet maintains a large gain bandwidth product and a fast slew rate.

Each of these JFET-input operational amplifiers incorporates well-matched, high-voltage JFET and bipolar transistors in a monolithic integrated circuit. The devices feature high slew rates, low input bias and offset currents, and low offset-voltage temperature coefficient.

The TL081, TL081A and TL081B are high speed J–FET input single operational amplifiers incorpo-rating well matched, high voltage J–FET and bipo-lar transistors in a monolithic integrated circuit. The devices feature high slew rates, low input bias and offset currents, and low offset voltage temper-ature coefficient.

Mar 6, 2025 · I have a new design which has 60V constant output voltage and maximum 0.5A current value. But when I connect the load 60V value changes 59.8-59.9V. So I want to adjust the Vout and closed loop control. I used pwm to get analog output and single supply amplifier to set voltage like Figure 18.