Feb 18, 2004 · here's the story, the plumbers in the building maint. department say there is a clog in the 8inch pipe down the line from the discharge.well when the pump runs,after about 30mins, it heats up and the amp reading are 6.4amps on each phase. the nameplate on the motor is 9.5amps on a 480volt connection.

Jan 29, 2005 · Smart Fasteners Thread starter nickta99; Start date Jan 29, 2005; Status Not open for further replies. ...

Jan 20, 2016 · 2. Using a new Excel 2016 or Excel 2013 with power query add on (free from microsoft) you can interogate the output file above using queries and some column and rows processing. The whole process is very graphic and interactive and you can do quite some smart stuff with it. (you can watch plenty of videos on youtube about power query in excel).

May 7, 2007 · Standard curves exist for control valves. You need to determine which trim exists. Some manufacturers provide tables showing the percentage travel and the valve coefficient Cv at each 10%, or each 10 degrees for rotary valves.

Jan 16, 2013 · I'm unable to change dimensions after I've created something in solid edge. For example, I drew a rectangle using the line tool, after it's been created, using smart dimensions, I'm unable to change the dimension of the rectangle. If I change the numbers in the box, it simply says dimensions...

Oct 20, 2005 · You could use a model dimension from a sketch. You are looking to create a foreshortened dimension. 1)Add the desired dimension to a sketch in the model.

May 2, 2006 · Hi, I'm new to pro/e and I've been working on editing some notes on drawings. I've notice different characters that obviously format the text/paragraph differently when inserted. This is one specific note pulled from the note properties dialog box: {0:NOTES:} * 1) SURFACES TO BE CONCENTRIC...

Jan 22, 2009 · Create your vertical Line with the start at 0,0,0. Now create a smart Point at X=0.50, Y=0.25, Z=0.00. Now open the 'Instance Geometry' function and using the Type 'From/To' select the Line and then select the Datum Point of the Datum CSYS as your 'From Location' and the smart Point you created as the 'To Location'.

Jul 21, 2006 · Double click on the view you want to be exploded and go to the View States tab in the View Properties dialog. When there Click the Explode components in view checkbox and pick an explode state from the lis

Jan 2, 2018 · The case I'm about to present below is easily solved by having our customer update the drawing to remove any discrepancies, but sometimes that is easier said than done. Also, the drawing follows the ASME Y14.5-1994 Standard. Material is defined as Acrylic Sheet per MIL-PRF-5425. The part itself...