It is not necessary to add or remove the jumper shunt on the drive for workstation/desktop use. For enterprise storage enviroments, use the following advanced settings: SSC Mode (Default 1): spread spectrum clocking feature enabled or disabled. Default 1 setting is disabled or jumper shunt placed on pins 1–2.

Feb 3, 2010 · Change the jumper settings ONLY if you intend to use the drive in an enterprise storage environment. For more information on these advanced settings, obtain the full version WD SATA Installation Guide at support.wdc.com. SSC_DIS Mode (Default) — Enable or disable the spread spectrum clocking feature. Default setting is disabled.

PHY stands for "physical layer". By jumpering pins 5 & 6 will cause the drive to go into a legacy 1.5 Gbit/s mode, rather than its default 3.0 Gbit/s mode. Check out the Wikipedia article on SATA for a bit more info.

Jun 27, 2012 · Those are jumper settings, similar to the IDE drives you mention, but for SATA specific options depending on the drive maker. For example, on this Western Digital support page for mobile drives, it shows two options: Reduced Power Spinup - RPS: Used by external hard disks to reduce spinup current and allows it to work over USB interface. Spread Spectrum Clocking - SSC: Used when your SATA ...

Mar 28, 2017 · Use the -ssc switch. The manual says it will "set case-sensitive mode".

Dec 23, 2023 · ASPM is a power management system that turns off the PCIe link to save power. The result is that while you may save power it can actively harm performance. From Wikipedia Active State Power Management (ASPM) Currently, two low power modes are specified by the PCI Express 2.0 specification; L0s and L1 mode. L0s concerns setting low power mode for one direction of the serial link only, usually ...

7-Zip does not have an explicit "quiet" or "silent" mode for command line extraction. A similar question over at Stack Overflow, Extracting a 7-Zip file "silently" - command line option, gives a possible solution using Python scripting code: One possibility would be to spawn the child process with popen, so its output will come back to the parent to …

Jun 22, 2014 · With Opal SSC-compliant drive this is not possible by design – assuming you initialized the drive properly before use, so that even a theoretical chance of vendor knowing the encryption key is left out. You might not trust in actual Samsung SSD's compliance to Opal SSC, but this is a different story.

I have a Lenovo Ideapad 110-15ACL 80TJ, and I want to enter the advanced BIOS settings on it. I don't mean the the regular BIOS, but the settings unlocked when a certain key combination is pressed ...

Jun 30, 2016 · 7z How to pass password and avoid prompt? Is there a way to pass in the password via pipe or any other method that can be automated? Try running the extraction commands with a similar syntax as in the below example to see if it'll work for your need setting the password variable accordingly beforehand passing it in or however you'd normally do that with the logic you use in your scripts, etc ...