This is all good..... but then, it says "For failover use the following ports for the reth and tie to redundancy groups" set interfaces xe-6/0/0 gigether-options redundant-parent reth0. set …

Have you configured reth-count using command, "set chassis cluster reth-count 15".. Also, if you configure and still it is not working, you add following command.. "set interfaces reth2 …

Oct 29, 2024 · Third - If is not possible to use reth and irb in same time, for example for reth0.111 and irb.111 does that mean that all configuration for reth0 it should be change to IRB. I mean …

Now, we'll increase the reth-count to match the number of physical interfaces on the unit set chassis cluster reth-count 8 Now change the redundancy-group to port mapping so that the …

Hi, if you need vlan-tagging on redundant interfaces, where do you put the vlan-tagging configuration? in the physical interface config (ge-x/x/x) or the reth i Log in to ask questions, …

May 28, 2023 · Not sure, but it looks like you are confusing reth (redundant ethernet) with ae (aggregated ethernet or port channel on Cisco). With reth interfaces these are configured as …

You should be able to ping to the reth interface IP. Just check if you have associated the reth interface with a zone correctly and then most importantly you have ping as host-inbound-traffic …

Reth interfaces are generally used as L3 interfaces. In you configuration I see that you need a L2 interface (running ethernet-switching) to be able to have multiple switches connected to same …

Mar 14, 2023 · Reth is short for Redundant Ethernet interface. These are used on clusters of two SRX devices as part of the failover mechanism. With Redundant ethernet a pair of ports back …

Now if both reths are in different zone then this might not serve will the design, because if one reth is unable to reach remote gateway (suppose this is primary link to reach remote gateway ) …