Dec 8, 2015 · On the push-rod suspension, the rod is located high in the vehicle and attaches to the lower control arm. Inherently, the working parts of the pull-rod suspension can be placed lower in the vehicle, which equates to a lower center of gravity. The problem with this is it makes it harder to get to for tuning or if in need of repair.

May 11, 2023 · If the rod goes in as far as it went when the mower was new, then it's in all the way. Maybe try to push / pull it a few times to see if it always goes in the same distance.

May 4, 2017 · The threaded rod goes into the plastic clips, which have teeth that engage the timing chain. The whole thing gets wedged between the timing chain and the upper chain guides.

What you see looking at you is the end of the R&P unit with the outer tie rod end and coupler (is that what it's called??) pulled off. The black portion of the is the seal.

TLDR: To do it right and not have to do it again in a month (or possibly right after start up), the only way to fix this is to either pull the crankshaft and have it turned, as well as check the connecting rod, or replace the engine (might make more economic sense to …

Oct 11, 2011 · Today I think I pulled my handbrake maybe a little too hard to stop my self from rolling down a hill. The stick is now loose and it engages only when I pull it to the very top. I can pull it up wit...

Aug 17, 2011 · I have a ball joint and a tie rod end that both have bad boots. The ball joint boot is ripped at the center around the entire circumference. The tie rod end's boot isn't ripped, but it has come up from it's bottom seat and I see a bit of grime has gotten in. There is no play at all in the suspension. There is no pull while driving.

May 30, 2017 · 99 Chrysler Concorde, new starter manufactured by Chrysler, Autozone tested the battery and said it had 73% health and was fully charged. What is the reason why my car won't start?

Aug 29, 2016 · Here's an example using a scope, this came in after a head gasket replacement and you can see the balancer is slightly off. Yellow: Cylinder 1 Compression Blue: Crank Position Sensor Green: Cam Position Sensor To find TDC without special tools Pull all the spark plugs and remove the cylinder head cover if it hasn't already been removed.

Aug 12, 2019 · This rod also has a weak spring connected with it, to reduce the risk of the butterfly valve chattering/vibrating. The action of the governor lever, moving under the influence of the governor weights, is to close the throttle butterfly. This means, when well adjusted, the mere running of the engine is pushing on the rod force the throttle closed.