VX1000 ‒ Measurement and Calibration Interface Hardware - Vector
Attached to the debug interface of the microcontroller, the Serial POD provides direct RAM access through JTAG, SWD, Zipwire or DAP. Its tiny form factor provides a perfect fit for all use cases and environments.
XCP | Measurement and Calibration Protocol | Vector
A plug-on device (POD) is connected directly to the controller on the ECU, e.g. via DAP, JTAG, Nexus, Aurora, etc. The POD transmits the data to a base module that acts as an XCP-on-Ethernet interface.
VX1161 - Compact Measurement and Calibration Hardware for ... - Vector
The VX1000 system is a scalable, high performance solution for your ECU measurement and calibration needs. The VX1161 Multi Base Module is the ideal solution for measurement and calibration of multiple ECUs in a network.
- VX1000 serial POD not detected - Knowledge Portal - Vector
- - Issue: My (new) serial POD (VX1544A/VX1544B or VX1543A/VX1543B) is not detected. The corresponding POD.
The VX1000 hardware enables measurement and calibra-tion tools such as CANape to access ECUs with high perfor-mance and marginal impact on runtime. It is designed for use in vehicles, but can also be used on test benches and in the laboratory.
VX1000 hardware can be used to monitor bus communication like CAN and FlexRay or can be used to measure internal ECU values via an additionally installed POD. This document describes functionality and shows screenshots of INCA 7.4.7 and VXconfig 4.7.
POD Interface Cards VX1161.31A Serial VX1161.32B HSSL VX1161.32C HSSL2 Network Interface Cards VX1161.41A 6x CAN VX1161.41B 6x CAN 1x FR VN5130 3x Automotive Ethernet TAP Streaming Interface Cards VX1161.51A/.52A 4 2x TAP FPDLINK3 TI954/TI953 VX1161.51B 4x RX FPDLINK3 TI954 VX1161.51C/.52C 4 2x TAP GMSL2 MX9296A/MX9295A VX1161.51D/.52D 4 4x RX ...
Configure the VX first, then connect to your ECU! But: You need to write the changes to the Base Module or POD after resolving the inconsistency! Note: Depending on the use case, a selection between one of the two has to be made.
The plug-on device (POD) is connected directly to the AURIX radar microcon-troller via the Aurora interface and 4 LVDS lanes. The POD transmits the data to the VX1135 base module at up to 5 Gbit/s over the Vector High Speed Serial Link (HSSL2).
VXtools Release Notes - Vector
Added support for VX1522.01 GMSL2 POD v1.3 and newer for VX1161.51. Network Interface Drivers. Updated VX1135 driver to v25.10.10, now supporting upcoming VX1135 variants with NXP TJA1462BT CAN SIC transceivers on all CAN channels.