3. Position the fabric with the edge of the fabric against the guide of the presser foot and then lower the presser foot. 4. Rotate the handwheel toward you. - Check that the needle does not touch the presser foot. 5. Sew with the edge of the fabric against the presser foot guide.

4. Sew with the edge of the fabric against the presser foot guide. - The needle drop point will be slightly over the edge of the fabric. After adjusting the stitch width, slowly turn the hand wheel toward you (counterclockwise) and check that the needle does not touch the presser foot. If the needle hits the presser foot, the needle may bend or ...

4. After adjusting the stitch width, slowly turn the hand wheel toward you (counterclockwise) and check that the needle does not touch the presser foot or the needle plate. 5. If using a twin needle: - Make sure that when you insert the twin needle it touches the needle stopper. Then tighten the needle clamp screw securely.

Raise the presser foot lever. 4. Press the black button on the presser foot holder and remove the presser foot. 5. Place the new presser foot under the holder aligning the foot pin with the notch in the holder. - Lower the presser foot pin until it snaps into the notch in the holder. 6. Press to unlock all keys and buttons. 7. Raise the presser ...

1. The upper threading could be threaded incorrectly - Re-thread the top thread. - Check that the upper tension is correct.

8. Position the fabric under the presser foot, and then press the S tart/S top button once. - After reverse/reinforcement stitches are sewn, the machine starts sewing. 9. After reaching the end of the stitching, press the Reverse/Reinforcement stitch button once.

- Set the presser foot pressure weaker if the material is stretched, if the material has multiple layers that are not fed evenly, or if the material is damaged by feed dogs. - Set the presser foot pressure stronger if the material has slipped and is not feeding properly. 3. When you are finished sewing, reset the dial to 3 (standard). 4.

Use the ball point needle for best results when sewing patterns using mongramming foot "N". We recommend needle HG-4BR (Organ). Schmetz needles “JERSEY BALL POINT” 130/705H SUK 90/14 may be used as a substitute. Transparent nylon thread. Use a 90/14 to 100/16 needle, regardless of the fabric or thread.

1. Make sure the foot controller is plugged all the way in on your machine and in the receptacle. 2. Turn the power switch to the ON position. 3. Check the foot controller. - Make sure the foot controller is plugged into the pin jack outlet. - Press the foot controller down lightly, and the machine will run at low speed. 4.

Follow these instructions below to install the walking foot. 1. Lift up the presser foot and needle and turn the power OFF. 2. Remove the presser foot and presser foot holder. 3. Attach the walking foot by slipping the forked part of operation lever located on the right side of the walking foot onto the needle clamp.