Apr 27, 2007 · we are planning to replace plain Hex nut with Nyloc Nut. After tightening of Nyloc Nut using DC Nutrunner, retained torque using dial type torque is coming just half-of the torque applied using NR. this not happening with plin nut. is there is any major torque loss if we use Nyloc nut using DC Nutrunner. Regards, Reddy P C

Feb 1, 2011 · If the nylock nut is sitting in a concave or indention I would just leave it upside down as mating contract area is probably greater this way. And it might work better as the nut's crown fits into the mating hole it will not allow the bolt to slide side to side in the hole. Same principle as a lug nut against a stamped steel wheel.

Jun 19, 2012 · If the Nut is loosened and taken out, the same NUT can be used and TIGHTEN to GET Half the Fibre undergoes Compression. The same is the case for 3rd Time use, where the compression is made to three fourths. Thus 4 times it can be used. The PHILOSOPHY is AS LONG AS THE COMPRESSIBILITY is NOT EXHAUSTED for the Nylon FIBRE the same Nut …

Jan 25, 2008 · The bolt in guestion is for mounting a ss vent can to the end of the hub (the end that holds the blades) the housing is fibreglass and the seam has ss nut plates the top 3 holes have a ss bolt screwed inward and a ss Nylock nut on the inside, the problem is the bolt backs out while the nut is installed, we have put locktite (red & Blue) on it ...

Dec 11, 2012 · Thus, I suspect that I may have had a fractured and flaking galled surface inside the nut before I installed the screws. The 1/2"-13 hardware on tower mounted equipment would have been reasonable quality hardware (McMaster Carr, MSI, Bolt Depot, etc.) but would have been matching grades of stainless installed dry.

Feb 1, 2011 · Re: How to unscrew a nylock nut 02/01/2011 1:40 PM I'd think they can still be re-used without any problems, but if you really want to, they may be thermo plastic, so you could screw them on, and melt the plastic, or you could use a little locknut solution.

Sep 25, 2014 · If you are designing a fastening device with stainless components, ostensibly to meet load, reusability, size requirements, corrosion resistance, I would want to know what works well. We have used 304 and 316 SS 15mm or 5/8" bolts with nyloc nuts to fasten very large steel solar mounts for about 7 years.

Apr 10, 2019 · Nut screws washer and bolts. The nut get the spring washer and the bolt head the flat washer. But if you are smart, you add a flat washer after the spring washer to save damaging the substrait surface, i.e. galvanise, epoxy paint. Nut, spring washer, flat, flat, bolt head. And a touch of locktite on the threads. Torque. Job done, no charge, no ...

Aug 20, 2008 · Hi i want to ask one question regarding Bolt&Nut threads.For example suppose i have bolt in RH thread and i want to fit it with nut so i need LH type thread or RH type thread.Please clarify. thanks. Binoi.S

Oct 5, 2016 · Rather than 304 ( stronger than 316, but also more apt to corrode), stainless, use bolts with F593C stamped on the head, much stronger, and as corrosion resistant as 316 grade. We then use a stainless washer over the motor mounting hole, to spread the nut load a bit. We use longer bolts to allow double nutting, rather than nyloc nuts or Loctite..