Jul 2, 2015 · From the Kahr website: "Differences between the Kahr CW380 and Kahr P380 models include: the CW series has a conventional rifled barrel instead of the match grade polygonal barrel found on P models; the CW slide stop lever is MIM (metal-injection-molded) instead of machined; the CW series slide has fewer machining operations, and uses simple roll marking instead of engraved markings; the P380 ...

Jan 25, 2015 · Blazer Brass & PMC Bronze for range ammo. Hornady Critical Defense for carry. My CW380 is finicky and has choked on UMC, WWB, etc.

Jan 8, 2016 · That's a refreshing change from the posters who pizz and moan about their problems and bad mouth Kahr Arms or Kahr service. I'm going to present you with the Bawanna award for meritorious posting and the Muggsy seal of approval.

Jan 15, 2014 · The Kahr design (and a safety feature) is a long, very smooth trigger pull. My P380 runs about 7 pounds which is very good for a carry piece and not hard to use at all.

It can be done on the CW380 even when recoil springs are new, but its a bear and takes practice. But no question the smallest Kahrs are harder than other guns, especially when the springs are new. In fact Kahr's recommendation is to load the chamber using the slide release. One option: Start with an EMPTY MAGAZINE in the receiver.

My new CW380 after break-in was flawless except it was plagued with light primer strikes and was returned once for repair. The barrel, striker and recoil springs were replaced by Kahr causing failure to feed and slide not locking back after last round problems with the light primer strikes seeming to be much worse.

Jan 24, 2017 · Between seeing how messed up his CW380 was and previous experience with their service (through Magnum Research, which is Kahr owned), and all the reports of poor quality and customer service on the internet and in the community, I've …

Jul 25, 2015 · I have multiple CW380 pistols. I tried the usual greater than 200 round break in. I continued to have multiple premature slide locks and failures to feed. I ordered multiple P380 machined slide locks and continued to have premature slide locks and failures to feed, even with adequate lubrication and frequent chamber cleaning. I partially grinded the portion of the slide stop that interfaces ...

Jan 18, 2014 · Does anyone know what the trigger pull weight is on the new CW380 or the older P380? I am looking to replace my LCP & do not want to get back into a long heavy trigger. Thanks Mike:amflag:

Nov 23, 2014 · I don't know if this has been done to death, but I thought it might be useful to recount what has worked well and what hasn't worked well so far in my CW380. This gun has had a few hundred rounds through it at this point, and has been mostly smooth running.