Jun 27, 2001 · Because this is a frequently asked question, I went digging through info for '01 ALH and made the following list of known reasons for the glow plug light to flash. They are listed with the VW code and generic reader P code. 00741 Brake pedal monitoring - implausible signal 01044 Control unit...

May 7, 2005 · How to repair stripped or otherwise damaged threads of a glow plug (g.p.) without removing the cylinder head This repair does require that the g.p. is not stuck or broken off in the head. You can see, these threads are totally gone at …

Nov 9, 2003 · With 159,000 miles, on this 10 year old Passat; the rubber on my glow plug wires is falling off (crumbling) away. Replacing the 7 volt NGK Glow plugs was pretty easy. Since I like my equipment in top condition; I ordered new glow plug wires from 1stVWparts (Auburn VW) and they are actually pretty affordable.

Apr 6, 2003 · Let me also express my gratitude for your detailed post on replacing the glow plug harness. I recently bought a 2000 Jetta with the CEL on, the owner thought the culprit was the MAF which he had just recently replaced. Vag-Com indicated the fault was 16764, I replaced the glow plug harness, cleared the CEL and have not had a problem since.

Dec 22, 2011 · Replacing the glow plugs is similar to spark plug changes. Use the correct 6-point 10mm deep socket set squarely on the plug, and they should back out. If they don't, resist the temptation to force them. Put some penetrating oil on them and wait a day or 2 then try again.

Aug 22, 2014 · Hello. This tractor has 433 hrs, purchased new. Just recently changed oil and fuel filter. Very hard to start when cold. When warm it starts right up. When cold it takes 5-6 long start attempts to start. During these attempts it blows white smoke. I've read the posts about hard starting and one...

Dec 16, 2022 · The injector and glow plug go into a separate chamber off the main combustion chamber. Here's a pic of an IDI head off an earlier Branson with a Yanmar-derived engine below. The round thing with the small square port is the plug that forms the …

Jan 23, 2019 · From what I can tell from the schematic the ignition switch turns counter-clockwise to engage the glow plug circuit. When the indicator "glows red", you then turn the key clockwise and start the engine. The glow plugs are the pencil type wired in parallel. Here's an image of the ignition switch schematic and this mysterious "glow indicator ...

Feb 8, 2013 · Eventually found "over the hill tractors" on flea bay and ordered a 4 plug set for $79.99 plus $4 shipping. They arrived today, each one measures about 1.1 Ohm, so the set is going to draw something close to 50 amps, OK.

Nov 8, 2010 · The system consists of eight glow plugs (one for each cylinder), control switch, power relay, wait lamp and a wiring harness which incorporates eight fusible wires (one for each glow plug) located between the wiring harness and the glow plug terminal. (Fig. 17). The system is activated by the ignition switch being turned to the On position.