May 5, 2006 · What font did they use on the 1947-1954 GMC ???? I have lots of font books and can not find it Maxx

6 days ago · What font did they use on the 1947-1954 GMC ???? I have lots of font books and can not find it Maxx

May 29, 2012 · i just bought a 9' 2" long bed off a 1949 GMC one ton that was a Saskatchewan grain truck with a hydraulic tilting p/u box with regular rear fenders. I plan on putting it all onto my 47 Studebaker one ton flat deck so that I'll end up with a wide rear ended 40's dually pick up. i will have to extend the fenders outward in order to clear both ...

May 6, 2017 · I am redoing the brakes on my 1957 GMC Napco 4x4 half-ton. The front brakes are entirely different from the back. Does anyone know anything about this different style of brake shoe? I have found drums and wheel cylinders but am having a tough time with the shoes and hardware kits. Thanks for any help. Mark

Jan 14, 2025 · The new 21 circuit wiring harness I installed only had 2 two prong flashers. One for signals and one for hazards.

Dec 4, 2019 · A 261 engine would bolt right in, would help some. Look for tubeless(22.5) rims, work on P-30 front spindles, two speeds are almost all low and lower ratios, so don't waste your time there.

Dec 4, 2007 · I'm not familiar with the inside mechanics of them, but the 5-Speed GMC's I used to drive could be shifted without the revs just perfect, unless they were a little old and needed some help, but the Road Rangers I have driven needed to be shifted just about perfect, especially downshifting and very simialr to the two-stick Brownie shifting we ...

Dec 17, 2018 · Just a SWAG, but I believe the GMC is a bit heavier. However, the better gas flow through the GMC cylinder head would probably make the added HP and/or torque gain of the GMC over the Chevy offset the weight advantage of running the Chevy. Chevy ports suck like a Hoover upright vacuum cleaner, with no practical way to improve the flow.

Feb 28, 2007 · Hello all,well I finally started on my 63 Gmc 3/4 ton.The diffs are out and apart,and I noticed the front had been rebuilt at one time,looked like a gear failure.Any how the font is a 375 ratio and the rear is a 410 is this normal?

Apr 12, 2006 · Hello, I am looking for the valve adjustment specs. and procedures for a 53' gmc 228. I have the factory repair/overhaul manual but I am only able to find specs and adjustments for 1 and 6. If anyone could point me in the right direction to how or where I could find these it would be greatly appreciated. This will get me on the road!