Feb 5, 2019 · I just bought a clutch pedal bump stop for my 1980 elco 4 speed. It didn't previously have one in it and I can't seem to find anywhere online with a how to...

Feb 7, 2007 · Do you mean a positive stop for the pedal travel? That should go on the firewall or floor, not downstream on the linkage. Be sure the clutch disengages totally, measure with a feeler gauge, and be prepared to adjust it a lot. That's really a racing item and you already know how weak our firewalls are. I'm thinking it will require some reinforcement at the mounting point.

Jul 19, 2015 · done a 4-speed conversion on 1978 malibu. have to take all free play out of pedal to get transmission to shift smooth. any ideas on what the problem is? used 4-spd conversion kit from dixie monte carlo, hay-85-100 street clutch kit …

Apr 22, 2009 · The pedal is slightly higher than the brake pedal, but once I make the stop for it, it'll be the same height. Also I get complete release of the clutch about 2" before hitting the floorboard with the pedal.

Jan 10, 2019 · I used third gen camaro clutch pedal, what I did was grind off the camaro clutch pedal assembly, and welded it to the automatic pedals and then swapped the camaro brake pedal arm over to the original pedal as well since the pad is smaller. Used third gen clutch master and slave cylinder with custom braided clutch line.

Feb 16, 2009 · Hydraulic clutch parts for G bodies are available but are either expensive or not fully featured. My goal is to have a pedal that was affordable, using factory parts for ease of replacement and had fully featured parts for the cruise shutoff and startup cutout. You need 1. early (83-88 ish)...

Dec 3, 2021 · Hey All, Looking for some help with a manual linkage/clutch pedal install in a 78 malibu originally equipped with a th350. I am using the clutch pedal/linkage kit similar to the OPG kit (see pic). I just need a little help getting started, installing the pedal and where the bracket goes on …

Mar 15, 2019 · It was a nice day yesterday so I made some final adjustments to my clutch linkage. I re-adjusted the spherical ball-end linkage so it better duplicated the stock upper push rod in length and position. Now I see better alignment with the pedal arm and Z-bar mounting points. But when I adjust the...

Dec 3, 2021 · Hey guys, 78 Malibu, carb LT1 with T-10 four speed, G body mechanical clutch kit. Using a 10.5” flywheel for an 87 Camaro and a 10 spline clutch for a 63 Vette (what the trans was originally in) I have a decent little clutch shudder from a dead stop that I …

Nov 4, 2010 · I don't follow. Are you saying the pedal's travel is too short? Do the brakes work properly? You can adjust pedal height as described, but the pedal travel is dependent on the master cylinder, caliper bores, and wheel cylinder bores. A large MC bore will reduce travel while increasing effort.