Mar 11, 2023 · Using 2 DI's for those two warning lamp inputs would certainly allow you to set up logic in the ecu to trigger the CE light as well as normal CE light functions via virtual aux or GP outputs.

Jun 24, 2012 · so i wish to setup my check engine light as both an indicator for any ecu fault codes as well as a warning light for other potentially harmful situations. these include: -Excessive knock values (>xx) (side note; what sort of figure is considered excessive knock?) -Overrev (RPM>8000) -Overb...

Aug 30, 2020 · When using E-Throttle and mode is set to quiet throttle. Doing the throttle position greater than 80% and key on for 10 seconds to reset the CE Light won't work. Is that correct? I assume it use TPS not APS?

On plugin ECUs there are two LEDs on the top board, one is a power LED, the other is a CE LED, as above, if the CE light is flashing, don't panic just yet. If your ECU should have power, and the LED is not lit, check the following: Inspect the ECU Plug, refer to the manual for power and ground pinout information.

Fit the Link Plug-In ECU: Remove the ECU from its packaging, unplug the USB cable from the socket on the topboard and place ECU into the factory enclosure. Ensure the PCB is slotted …

Dec 11, 2024 · LinkECU's engine management software, PC Link, gives you the power to configure ECU functions, analyse data logs and update your ECU in real-time.

May 5, 2020 · Plug in Laptop with the PC-Link software on it so you can check/clear the error. Well logged in ECU and very interesting to say the least. Could only find the TPF in % but cleared the fault but easy and explains how with helpful tips.

Check Engine Lamp functionality to display ECU fault codes on the dash. Various modes for light operation. Internal OEM level wideband Lambda sensor control using latest Bosch digital signal processing technology. Built in calibrations for many industry standard and OEM sensors as well as custom 2 point and tabled calibrations.

Apr 9, 2022 · In PCLink's CAN setup, add a new stream and put CAN Aux 1 (CE Light) as the parameter with a start position of 56 and only 1 bit wide. Then add any others you you may want, like I did adding the Oil Pressure Low.

Aug 31, 2021 · SHIN@Dunk88のブログ記事「DunkをLink化 番外編 6 CEランプとエアコン制御」です。