2A9A DME: Crankshaft - inlet camshaft, synchronization. Service Notes. 1. Check signal wire for short to positive, ground, open wire. 2. Replace camshaft sensor. 3. Check positions (valve timing setting) of camshaft reluctors 4. Check timing chain and chain tensioner assembly. 5. Check VANOS solenoids for dirt and contamination

2a9a and 2a9b, 2010 328i x drive, no start, Do 73 at risk, new cam inlet sensor, new crank sensor, replace e fuel pump Gary R. | Expert 2,290 Satisfied Customers

Jun 29, 2024 · 2A9A Code MAY be an issue with the wiring between the Intake Cam Position Sensor Connector (at sensor) and the Connector at DME. If you had the Valve Cover off to do VANOS bolt repair recently, the harness could be pinched or damaged. The A559 code is probably secondary to discharged battery from the Starter Cranking.

2a9a and 2a9b, 2010 328i x drive, no start, Do 73 at risk, new cam inlet sensor, new crank sensor, replace e fuel pump Gary R. | Expert 2,304 Satisfied Customers

2a9a and 2a9b, 2010 328i x drive, no start, Do 73 at risk, new cam inlet sensor, new crank sensor, replace e fuel pump Gary R. | Expert 2,138 Satisfied Customers

Customer: I have a code 2A9A Crankshaft - inlet camshaft synchronization message. Have swapped the camshaft sensors over and the same for the vanos solenoids - cleaned and replaced. Have swapped the camshaft sensors over and the same for the vanos solenoids - cleaned and replaced.

2a9a and 2a9b, 2010 328i x drive, no start, Do 73 at risk, new cam inlet sensor, new crank sensor, replace e fuel pump 2010 BMW 328i No Start Issue? Expert Troubleshooting Guide

2A9A Cam sensor, inlet signal - signal invalid for synchronization There is a BMW bulletin on this code, which I have provided below. You may or may not have the exact issue as referenced in the bulletin, a proper diagnostic will be required to determine if it …

Customer: fault code 2a9a inlet side Mechanic's Assistant: Just to clarify, what's the exact code? And have you tried to reset it? Customer: e66 n52 Mechanic's Assistant: What is the model/year of your BMW? Customer: 2008 i reset n came back as history again Mechanic's Assistant: Are you fixing your vehicle yourself? What have you tried so far?

2a99 and 2a87 code and occasionally a 2a9a with a long crank. Car is in limo mode at the moment. Mechanic's Assistant: Just to clarify, what's the exact code? And have you tried to reset it? 2a99 - crankshaft - exhaust camshaft reference. Mechanic's Assistant: What is the model/year of your BMW? 09 335i. Mechanic's Assistant: Are you fixing ...