Periscope Logic Lights - Printed Droid
The Periscope Logics are a custom PCB kit for Matt Zwarts Domelift Periscope – but should fit almost all Periscopes. It needs 5V and can run standalone or be controlled via serial command or I2C. Firmware is still not final but running the needed sequences.
Electronic periscope - General Guidance - Arduino Forum
Mar 2, 2020 · Hello, I have to build electronic periscope. It should look like "T". We mount FPV Stereoscopic googles on head and we mount periecope to it. On left and right side of "T" we have two cameras and each camera send video…
Employee #R2-D2 : 8 Steps (with Pictures) - Instructables
3D printed periscope (scaled down so that the base is approximately 1-3/8 inches in diameter). 1-3/8" dowel, about 4-5 inches long. Tools. Credits. I'm probably the most proud of this step, because the geometry here is bizarro, but simple at the same time.
Low Cost Digital Microscope With Automated Slide Movement
The design utilizes an Arduino UNO along with the Easy Driver from Sparkfun. The easy driver allows microstepping and facilitates slide movement at high resolution. Gridwise movement of the slide is achieved by using one motor at a time, as shown in the figure.
R2-D2: Automating the Pie Panels - The Geek Pub
Apr 17, 2019 · I’ve decided to automate four the the five pie panels. The 5th and 6th are a holo projector and the periscope. I’ll be adding the periscope at some point in the future, and so for today that pie panel will just be attached with industrial two sided tape. I purchased the ultimate hinges that Kevin Holme makes.
Ascenceur pour periscope R2D2 - Français - Arduino Forum
Nov 22, 2016 · Je suis actuellement en train de réaliser un ascenseur pour mon R2D2 taille réelle. J'utilise un moteur pas a pas Nema avec un contrôleur easy driver et un arduino Uno.
Using an Arduino UNO to change R2's Periscope Lighting Modes
Oct 31, 2012 · I'm using the Arduino UNO's pins 8, 9 and 10 to toggle the leads to HIGH (open) or LOW (GND/OFF). I named a few of the modes wrong, the Arduino was on and well thru some of the cycles before I...
drolsen/r2-periscope-lighting: R2D2 Periscope Lighting PCBs - GitHub
Jan 18, 2024 · Purchasing R2D2 periscope lighting PCBs; Constructing the PCBs; Uploading Code / Testing & running PCB lights
jwace81/R2D2-Periscope - GitHub
Work in progress lighting system for the periscope in Matthew Zwarts lift system.
Put Together A Periscope | Jaycar Australia
Make your own periscope with Jaycar's Mini Makers range! Put together a periscope with easy-to-follow instructions and materials from Jaycar.
- Some results have been removed