Sep 22, 2020 · 6V6 is one of my favourite tubes and I have run them in triode/ultralinear/pentode mode at Vak voltages between 270 and 380V (for both guitar amps and HiFi Amps). Around …

Jun 27, 2017 · You'll notice in the photo of the completed amp I used both octal and 7-pin sockets to allow for either 6AQ5 or 6v6 tubes. I even added an A/B- slide-switch in the filaments to …

Jul 3, 2016 · A pair of 6V6 should get about 12W in UL mode with quite low distortion, if there is enough negative feedback. The only draw back with UL is the screen grids run at a similar …

Dec 21, 2009 · A DIY Push-Pull (PP) 6V6 Tube Amplifier built following the Dynaco A-410 6V6 Tube Amp Schematic.

Oct 4, 2008 · I've just been trying out different bias settings on my DRRI (it has two Groove Tubes 6V6's) and based on what I've read, the maximum plate dissipation for them is 12W, and the …

Jun 19, 2013 · I have a chassis and the necessary iron (including choke for power supply) to build a STEREO basic amp with 2 pairs of 6V6's in push-pull. I have on hand an Arkay A12, Radio …

Jan 31, 2023 · My scratch-built 6V6 PP AB1 amp runs in pentode mode with 380V plates and 324V screens and it sounds awfully good. I think actually you will have a better chance of …

The author has plans for a pair of mono-bloc 6V6 push pull amplifiers with Hammond output transformers and DC-DC converts for both heater supply and main HT - all powered from a …

6V6 PP Dynaco 10W THD 0.4% very musical tube power stereo amplifier PCB 1 pc ! This is a bare PCB of a stereo 6V6 push-pull tube amplifier. The driver tube is a single 6SL7 at the input.

Apr 1, 2018 · I was stating the Scott 299A makes 15 watts per channel using push-pull 6BQ5 tubes., The Poindexter amps makes 6 watts per channel triode connected. A triode connected …