MCU.GPIO_B – device1.SDA – device2.SCL. Depending on how you configure your i2c pinmux (or bit-banged i2c) you will reach either device1 or device2.

I2C is wonderful in that you can put a large number of devices on your bus ... ADDR here is set by connecting it to SCL/SDA/GND/VCC (4 bits with one pin), and, INT pin here is called ALERT.

Each device can be unplugged from the I2C bus oneat a time and the bus state observed until both SCL and SDA goes high.In case the I2C lines of each device cannot be disconnectedindividually, each ...

The I2C bus is a set of hardware and software rules that allows communication between multiple devices over a shared, two-wire interface. In operation the bus uses one line (SDA) for data and the ...

In transactions involving I2C target devices, the SCL clock signal generally has a duty cycle of approximately 50%, but when communicating with known I3C targets, the bus controller may switch to ...

Bus developed by the MIPI Alliance is a two-wire interface built on the foundation of I2C with advancements to improve speed and efficiency. It is designed to replace I2C (and partially SPI) while ...

The discrete I2C isolator is among the most often considered isolators. This most stubborn, ... (SCL), the other for data (SDA). Bus access is via open-drain outputs (Fig. 1).

I2C is so essential because it’s so well adopted across many integrated circuits, ... ( Note: SCL is meaningless for most of the time, ...